Adc SG-1 Bedienungsanleitung PDF herunterladen (Seite 146)

Chapter 7: Second Level Commands June 30, 2006

7-66 SG1-UM-8500-03

<vc-id>

This assigns a VC ID to the virtual circuit between the system and the remote PE.

Example: Route VLAN interface through an MPLS L2 VPN based on Martini draft

Using the no mpls l2transport route command

It detects redirected interface traffic through MPLS l2vpn tunnel based on Martini draft.

Usage

no mpls l2transport route interface <Ethernet | VLAN> <slot>/<port number>/

[<sub-interface number>]

Parameter(s)

This is the SCC slot number; valid number range is 0 to 2.

This is the SCC port number; valid number range is 1 to 3.

<sub-interface>

This is the SCC sub-interface number; valid number range is 2 to 4095.

Example: detects VLAN interface redirection to MPLS L2 VPN based on Martini draft

Host(config)# mpls ip Ethernet 0\1

Host(config)# mpls l2transport interface 194.90.1.4 200

Host(config)# mpls l2transport route interface VLAN 0\1\100 194.90.1.4 200

Note: The system should refuse the mpls l2transport route command if the type is configured on the mpls

interface.

Host(config)# mpls l2transport interface 194.90.1.4 200

Host(config)# mpls l2transport route interface VLAN 0\1\100 194.90.1.4 200

Host(config)# mpls l2transport route interface VLAN 0\1\101 194.90.1.4 200

Operation error

Tunnel is used by another interface

Note: The system should refuse the mpls l2transport route command if the type is configured on the mpls

interface.

Host(config)# no mpls l2transport route interface

Host(config)# no mpls l2transport route interface VLAN 0\1\100

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 225 226

Keine Kommentare

Adc SG-1 Bedienungsanleitung Seite 146