ADC Migration Modules DSX-3 Bedienungsanleitung PDF herunterladen (Seite 17)

DETAIL ENGINEERING REQUIREMENTS Section 9, ATT-TP-76400

AT&T January, 2012

In those locations where space is limited and any of the new FDFs will not fit or cannot be

installed then at the request of the MEI/IE with the use of a JIM an older style bay may be

installed without the need for a waiver.

6.4.14 Under no condition, unless for testing or trouble shooting purposes, shall fibers be left

UNTERMINATED at any Fiber Optic Termination Panel (FTP). Examples of FTP’s would

include but may not be limited to FDF’s, LGX’s FDP’s, FIP’s or Fiber Drawers.

Any temporary test patch or loop back setup for testing or trouble shooting purposes shall not

be left up more than 24 hours unless concurred by the GNFO. Any loopbacks, which are

placed on the LGX at each end terminal site until integration testing can perform at either end

and cleared with the GNFO, is permitted. In these cases, a tag must be applied with the OTV

name, order number and date applied.

And, all fibers removed (unterminated) for testing or trouble shooting purposes shall have

dust caps placed over the end of the fiber as well as any vacated jack/port position a dust cap

shall be placed on that jack/port position.

Any fibers which are left as spares and are bagged and tagged and are required by the Telco

order to be left on site are also permitted.

9-17

1 2 ... 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

ADC Migration Modules DSX-3 Bedienungsanleitung Seite 17