Adc EMU-830 Bedienungsanleitung PDF herunterladen (Seite 23)

LTPE-UM-3159-02 2-1

Chapter

INSTALLATION

This section describes the procedures for installing the EMU-830.

EMU JUMPER SETTINGS

EMU-830s are jumper configurable for an RS-232 or RS-485 SLIP port interface. EMUs have an RS-232 factory

setting.

If you use the SLIP port to manage a shelf or shelves, you must configure the SLIP port interface before installing

the EMU-830. Do one of the following:

• For an RS-232 SLIP port interface, install the jumper on two-pin header connector P6 (Figure 2-1). This is the

factory default setting. Set the SLIP port baud rate as instructed in “Configure SNMP Operation Over SLIP” on

page 3-10.

• For an RS-485 SLIP port interface, remove the jumper from two-pin header connector P6 (Figure 2-1). Set the

SLIP port baud rate as instructed in “Configure SNMP Operation Over SLIP” on page 3-10.

Figure 2-1. Location of the SLIP Header Connector P6 on the EMU-830

Note: Each shelf in a Multishelf TAO network must have an EMU-830 management unit installed.

Inserting and removing the EMU-830 from a shelf will not affect the operation of the DSL cards installed in

the shelf.

An EMU-830 failure will not affect the operation of the DSL cards installed in the shelf.

RS-232

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 73 74

Keine Kommentare

Adc EMU-830 Bedienungsanleitung Seite 23